B-107
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix B Catalyst 3750 Switch Debug Commands
debug platform wireless-controller
debug platform wireless-controller
Use the debug platform wireless-controller privileged EXEC command to enable debugging of the
internal wireless LAN controller on a Catalyst 3750G Integrated Wireless LAN Controller Switch. Use
the no form of this command to disable debugging.
debug platform wireless-controller {all | packets | session | sm | wcp}
no debug platform wireless-controller {all | packets | session | sm | wcp}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform wireless-controller command is the same as the no debug platform
wireless-controller command.
This command applies only to the Catalyst 3750G Wireless LAN Controller Switch.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
all Display all wireless controller debug messages.
packets Display Wireless LAN Control Protocol (WCP) packet debug messages.
session Display wireless controller session debug messages.
sm Display wireless controller state machine debug messages.
wcp Display all WCP debug messages.
Release Modification
12.2(25)FZ This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show platform
wireless-controller
Displays information about the internal wireless controller.
To Next Page
Loading...
