Cisco Catalyst 3750 User Manual

2-760
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
spanning-tree bpdufilter
spanning-tree bpdufilter
Use the spanning-tree bpdufilter interface configuration command to prevent an interface from
sending or receiving bridge protocol data units (BPDUs). Use the no form of this command to return to
the default setting.
spanning-tree bpdufilter {disable | enable}
no spanning-tree bpdufilter
Syntax Description
Defaults BPDU filtering is disabled.
Command Modes Interface configuration
Command History
Usage Guidelines You can enable the BPDU filtering feature when the switch is operating in the per-VLAN spanning-tree
plus (PVST+), rapid-PVST+, or the multiple spanning-tree (MST) mode.
Caution Enabling BPDU filtering on an interface is the same as disabling spanning tree on it and can result in
spanning-tree loops.
You can globally enable BPDU filtering on all Port Fast-enabled interfaces by using the spanning-tree
portfast bpdufilter default global configuration command.
You can use the spanning-tree bpdufilter interface configuration command to override the setting of
the spanning-tree portfast bpdufilter default global configuration command.
Examples This example shows how to enable the BPDU filtering feature on a port:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# spanning-tree bpdufilter enable
You can verify your setting by entering the show running-config privileged EXEC command.
disable Disable BPDU filtering on the specified interface.
enable Enable BPDU filtering on the specified interface.
Release Modification
12.1(11)AX This command was introduced.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing