Cisco Catalyst 3750 User Manual

B-54
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix B Catalyst 3750 Switch Debug Commands
debug platform ip source-guard
debug platform ip source-guard
Use the debug platform ip source-guard privileged EXEC command to debug IP source guard events.
Use the no form of this command to disable debugging.
debug platform ip source-guard {all | error | event}
no debug platform ip source-guard {all | error | event }
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform ip source-guard command is the same as the no debug platform ip
source-guard command.
Related Commands
all Display all IP source-guard platform debug messages.
error Display IP source-guard platform error debug messages.
event Display IP source-guard platform event debug messages.
Release Modification
12.2(50)SE This command was introduced.
Command Description
show ip verify source Displays the IP source guard configuration.
show debugging Displays information about the types of debugging that are enabled.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing