Cisco Catalyst 3750 User Manual

2-24
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
authentication event
authentication event
Use the authentication event interface configuration command to set the actions for specific
authentication events on the port.
authentication event fail {[action [authorize vlan vlan-id | next-method] {| retry {retry
count}]} {
no-response action authorize vlan vlan-id} {server {alive action reinitialize} |
{dead action authorize}}
no authentication event fail {[action[authorize vlan vlan-id | next-method] {| retry {retry
count}]} {no-response action authorize vlan vlan-id} {server {alive action reinitialize} |
{dead action authorize}}
Syntax Description
Defaults No event responses are configured on the port.
Command Modes Interface configuration
Command History
Usage Guidelines Use this command with the fail, no-response, or event keywords to configure the switch response for a
specific action.
action Configure the required action for an authentication event.
alive Configure the authentication, authorization, and accounting (AAA) server
alive actions.
authorize Authorize the port.
dead Configure the AAA server dead actions.
fail Configure the failed-authentication parameters.
next-method Move to next authentication method.
no-response Configure the non-responsive host actions.
reinitialize Reinitialize all authorized clients
retry Enable retry attempts after a failed authentication.
retry count Number of retry attempts from 0 to 5.
server Configure the actions for AAA server events.
vlan Specify the authentication-fail VLAN from 1 to 4094.
vlan-id VLAN ID number from 1 to 4094.
Release Modification
12.2(50)SE This command was introduced.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing