Cisco Catalyst 3750 User Manual

2-346
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
macro global description
macro global description
Use the macro global description global configuration command to enter a description about the
macros that are applied to the switch. Use the no form of this command to remove the description.
macro global description text
no macro global description text
Syntax Description
Defaults This command has no default setting.
Command Modes Global configuration
Command History
Usage Guidelines Use the description keyword to associate comment text, or the macro name, with a switch. When
multiple macros are applied on a switch, the description text will be from the last applied macro.
This example shows how to add a description to a switch:
Switch(config)# macro global description udld aggressive mode enabled
You can verify your settings by entering the show parser macro description privileged EXEC
command.
Related Commands
description text Enter a description about the macros that are applied to the switch.
Release Modification
12.2(20)SE This command was introduced.
Command Description
macro apply Applies a macro on an interface or applies and traces a macro on an
interface.
macro description Adds a description about the macros that are applied to an interface.
macro global Applies a macro on a switch or applies and traces a macro on a switch.
macro name Creates a macro.
show parser macro Displays the macro definition for all macros or for the specified macro.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing