Cisco Catalyst 3750 User Manual

2-2
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
aaa accounting dot1x
Defaults AAA accounting is disabled.
Command Modes Global configuration
Command History
Usage Guidelines This command requires access to a RADIUS server.
We recommend that you enter the dot1x reauthentication interface configuration command before
configuring IEEE 802.1x RADIUS accounting on an interface.
Examples This example shows how to configure IEEE 802.1x accounting:
Switch(config)# aaa new-model
Switch(config)# aaa accounting dot1x default start-stop group radius
Note The RADIUS authentication server must be properly configured to accept and log update or watchdog
packets from the AAA client.
Related Commands
Release Modification
12.2(20)SE This command was introduced.
Command Description
aaa authentication
dot1x
Specifies one or more AAA methods for use on interfaces running
IEEE
802.1x.
aaa new-model Enables the AAA access control model. For syntax information, see the
Cisco IOS Security Command Reference, Release 12.2 > Authentication,
Authorization, and Accounting > Authentication Commands.
dot1x reauthentication Enables or disables periodic reauthentication.
dot1x timeout
reauth-period
Sets the number of seconds between re-authentication attempts.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing