2-124
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
diagnostic schedule
diagnostic schedule
Use the diagnostic schedule privileged EXEC command to configure the scheduling of diagnostic testing.
Use the no form of this command to remove the scheduling and return to the default setting.
diagnostic schedule switch num test {test-id | test-id-range | all | basic | non-disruptive} {daily
hh:mm | on
mm dd yyyy hh:mm | weekly day-of-week hh:mm}
no diagnostic schedule switch num test {test-id | test-id-range | all | basic | non-disruptive} {daily
hh:mm | on
mm dd yyyy hh:mm | weekly day-of-week hh:mm}
Syntax Description
Defaults This command has no default settings.
Command Modes Global configuration
Command History
Usage Guidelines Use these guidelines when scheduling testing:
• test-id—Enter the show diagnostic content command to display the test ID list.
• test-id-range—Enter the show diagnostic content command to display the test ID list. Enter the
range as integers separated by a comma and a hyphen (for example, 1,3-6 specifies test IDs 1, 3, 4,
5, and 6).
• hh:mm—Enter the time as a 2-digit number (for a 24-hour clock) for hours:minutes; the colon (:) is
required.
switch num Specify the switch number. The range is from 1 to 9.
test Specify the test to be scheduled.
test-id Identification number for the test to be run; see the “Usage Guidelines”
section for additional information.
test-id-range Range of identification numbers for tests to be run; see the “Usage
Guidelines” section for additional information.
all Run all diagnostic tests.
basic Run basic on-demand diagnostic tests.
non-disruptive Run the nondisruptive health-monitoring tests.
daily hh:mm Specify the daily scheduling of a test-based diagnostic task; see the
“Usage Guidelines” section for formatting guidelines.
on mm dd yyyy
hh:mm
Specify the scheduling of a test-based diagnostic task; see the “Usage
Guidelines” section for formatting guidelines.
weekly day-of-week
hh:mm
Specify the weekly scheduling of a test-based diagnostic task; see the
“Usage Guidelines” section for formatting guidelines.
Release Modification
12.2(25)SEE This command was introduced.
To Next Page
Loading...
Need help?
General
