Cisco Catalyst 3750 - Debug Platform Frontend-Controller

B-46
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix B Catalyst 3750 Switch Debug Commands
debug platform frontend-controller
debug platform frontend-controller
Use the debug platform frontend-controller privileged EXEC command to enable debugging of
front-end controller activity. Use the no form of this command to disable debugging.
debug platform frontend-controller {all | image | led | manager | poe | register | thermal}
no debug platform frontend-controller {all | image | led | manager | poe | register | thermal}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines This command is only supported on Power over Ethernet switches.
The undebug platform frontend-controller command is the same as the no debug platform
frontend-controller command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, start a session from the stack master by using the session switch-number privileged EXEC
command. Then enter the debug command at the command-line prompt of the stack member. You can
also use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
all Display all the debug messages for front-end controller.
image Display Image Manager debug messages.
led Display LED debug messages.
manager Display front-end-controller manager debug messages.
poe Display Power over Ethernet (PoE) debug messages.
register Display Register Access debug messages.
thermal Display thermal debug messages.
Release Modification
12.2(20)SE3 This command was introduced.