Cisco Catalyst 3750 User Manual

2-161
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
dot1x test timeout
dot1x test timeout
Use the dot1x test timeout global configuration command to configure the timeout used to wait for
EAPOL response from a port being queried for IEEE 802.1x readiness.
dot1x test timeout timeout
Syntax Description
Defaults The default setting is 10 seconds.
Command Modes Global configuration
Command History
Usage Guidelines Use this command to configure the timeout used to wait for EAPOL response.
There is not a no form of this command.
Examples This example shows how to configure the switch to wait 27 seconds for an EAPOL response:
Switch# dot1x test timeout 27
You can verify the timeout configuration status by entering the show run privileged EXEC command.
Related Commands
timeout Time in seconds to wait for an EAPOL response. The range is from
1
to 65535 seconds.
Release Modification
12.2(44)SE This command was introduced.
Command Description
dot1x test eapol-capable [interface
interface-id]
Checks for IEEE 802.1x readiness on devices connected to
all or to specified IEEE 802.1x-capable ports.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing