Cisco Catalyst 3750 - Debug Cluster

B-6
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix B Catalyst 3750 Switch Debug Commands
debug cluster
debug cluster
Use the debug cluster privileged EXEC command to enable debugging of cluster-specific events. Use
the no form of this command to disable debugging.
debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat | neighbors
| platform | snmp | vqpxy}
no debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat |
neighbors | platform | snmp | vqpxy}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines This command is available only on the cluster command switch stack or cluster command switch.
The undebug cluster command is the same as the no debug cluster command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
discovery Display cluster discovery debug messages.
events Display cluster event debug messages.
extended Display extended discovery debug messages.
hsrp Display the Hot Standby Router Protocol (HSRP) debug messages.
http Display Hypertext Transfer Protocol (HTTP) debug messages.
ip [packet] Display IP or transport packet debug messages.
members Display cluster member debug messages.
nat Display Network Address Translation (NAT) debug messages.
neighbors Display cluster neighbor debug messages.
platform Display platform-specific cluster debug messages.
snmp Display Simple Network Management Protocol (SNMP) debug messages.
vqpxy Display VLAN Query Protocol (VQP) proxy debug messages.
Release Modification
12.1(11)AX This command was introduced.