EasyManuals Logo

Cisco Catalyst 3750 User Manual

Cisco Catalyst 3750
1154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #141 background imageLoading...
Page #141 background image
2-111
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
deny (ARP access-list configuration)
deny (ARP access-list configuration)
Use the deny Address Resolution Protocol (ARP) access-list configuration command to deny an ARP
packet based on matches against the DHCP bindings. Use the no form of this command to remove the
specified access control entry (ACE) from the access list.
deny {[request] ip {any | host sender-ip | sender-ip sender-ip-mask} mac {any | host sender-mac
| sender-mac sender-mac-mask} | response ip {any | host sender-ip | sender-ip sender-ip-mask}
[{any | host target-ip | target-ip target-ip-mask}] mac {any | host sender-mac | sender-mac
sender-mac-mask} [{any | host target-mac | target-mac target-mac-mask}]} [log]
no deny {[request] ip {any | host sender-ip | sender-ip sender-ip-mask} mac {any | host
sender-mac | sender-mac sender-mac-mask} | response ip {any | host sender-ip | sender-ip
sender-ip-mask} [{any | host target-ip | target-ip target-ip-mask}] mac {any | host sender-mac
| sender-mac sender-mac-mask} [{any | host target-mac | target-mac target-mac-mask}]} [log]
Syntax Description
Defaults There are no default settings. However, at the end of the ARP access list, there is an implicit deny ip
any mac any command.
Command Modes ARP access-list configuration
Command History
request (Optional) Define a match for the ARP request. When request is not
specified, matching is performed against all ARP packets.
ip Specify the sender IP address.
any Deny any IP or MAC address.
host sender-ip Deny the specified sender IP address.
sender-ip sender-ip-mask Deny the specified range of sender IP addresses.
mac Deny the sender MAC address.
host sender-mac Deny a specific sender MAC address.
sender-mac
sender-mac-mask
Deny the specified range of sender MAC addresses.
response ip Define the IP address values for the ARP responses.
host target-ip Deny the specified target IP address.
target-ip target-ip-mask Deny the specified range of target IP addresses.
mac Deny the MAC address values for the ARP responses.
host target-mac Deny the specified target MAC address.
target-mac
target-mac-mask
Deny the specified range of target MAC addresses.
log (Optional) Log a packet when it matches the ACE.
Release Modification
12.2(20)SE This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3750

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750 and is the answer not in the manual?

Cisco Catalyst 3750 Specifications

General IconGeneral
Device TypeSwitch
Switching Capacity32 Gbps
Forwarding Rate38.7 Mpps
Stacking Bandwidth32 Gbps
RAM128 MB
Jumbo Frame SupportYes
Switch TypeManaged
ModelCatalyst 3750 Series
Uplink InterfacesSFP
Form FactorRack-mountable
MAC Address Table Size12, 000 entries
Routing ProtocolRIP, OSPF, EIGRP
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesLayer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)PoE
Operating Temperature-5 - 45 °C
Operating Humidity10% to 85% non-condensing

Related product manuals