Cisco Catalyst 3750 User Manual

2-75
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
clear arp inspection log
clear arp inspection log
Use the clear ip arp inspection log privileged EXEC command on the switch stack or on a standalone
switch to clear the dynamic Address Resolution Protocol (ARP) inspection log buffer.
clear ip arp inspection log
Syntax Description This command has no arguments or keywords.
Defaults No default is defined.
Command Modes Privileged EXEC
Command History
Examples This example shows how to clear the contents of the log buffer:
Switch# clear ip arp inspection log
You can verify that the log was cleared by entering the show ip arp inspection log privileged command.
Related Commands
Release Modification
12.2(20)SE This command was introduced.
Command Description
arp access-list Defines an ARP access control list (ACL).
ip arp inspection log-buffer Configures the dynamic ARP inspection logging buffer.
ip arp inspection vlan
logging
Controls the type of packets that are logged per VLAN.
show inventory log Displays the configuration and contents of the dynamic ARP
inspection log buffer.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing