2-697
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show power inline
show power inline
Use the show power inline user EXEC command to display the Power over Ethernet (PoE) status for the
specified PoE port or for all PoE ports.
show power inline [[interface-id | consumption ] | module switch-number] [ | {begin | exclude |
include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show power inline command. In the display, port 2 is configured
as static; power has been pre-allocated to this port, but no powered device is connected. Port 6 is a static
port in the power-deny state because its maximum wattage is configured for 10 W. The connected
powered device has a reported class maximum wattage for a Class 0 or Class 3 device.
Table 2-35
describes the output fields.
Switch> show power inline
Module Available Used Remaining
(Watts) (Watts) (Watts)
------ --------- -------- ---------
1 370.0 114.9 255.1
2 370.0 34.3 335.
Interface Admin Oper Power Device Class Max
(Watts)
--------- ------ ---------- ------- ------------------- ----- ----
Fa1/0/1 auto on 6.3 IP Phone 7910 n/a 15.4
Fa1/0/2 static off 15.4 n/a n/a 15.4
interface-id (Optional) Display PoE-related power management information for the
specified interface.
consumption (Optional) Display the power allocated to devices connected to PoE ports.
module switch-number (Optional) Limit the display to ports on the specified stack member. The
switch number is 1 to 9.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(19)EA1 This command was introduced.
12.2(25)SEC The consumption keywords were added.
To Next Page
Loading...
