2-430
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
policy-map
policy-map
Use the policy-map global configuration command to create or modify a policy map that can be attached
to multiple physical ports or switch virtual interfaces (SVIs) and to enter policy-map configuration
mode. Use the no form of this command to delete an existing policy map and to return to global
configuration mode.
policy-map policy-map-name
no policy-map policy-map-name
Syntax Description
Defaults No policy maps are defined.
The default behavior is to set the Differentiated Services Code Point (DSCP) to 0 if the packet is an IP
packet and to set the class of service (CoS) to 0 if the packet is tagged. No policing is performed.
Command Modes Global configuration
Command History
Usage Guidelines After entering the policy-map command, you enter policy-map configuration mode, and these
configuration commands are available:
• class: defines the classification match criteria for the specified class map. For more information, see
the
“class” section on page 2-67.
• description: describes the policy map (up to 200 characters).
• exit: exits policy-map configuration mode and returns you to global configuration mode.
• no: removes a previously defined policy map.
• rename: renames the current policy map.
To return to global configuration mode, use the exit command. To return to privileged EXEC mode, use
the end command.
Before configuring policies for classes whose match criteria are defined in a class map, use the
policy-map command to specify the name of the policy map to be created, added to, or modified.
Entering the policy-map command also enables the policy-map configuration mode in which you can
configure or modify the class policies for that policy map.
You can configure class policies in a policy map only if the classes have match criteria defined for them.
To configure the match criteria for a class, use the class-map global configuration and match class-map
configuration commands. You define packet classification on a physical-port basis.
policy-map-name Name of the policy map.
Release Modification
12.1(11)AX This command was introduced.
12.2(25)SE Support for policy maps on SVIs was added.
To Next Page
Loading...
Need help?
General
