Cisco Catalyst 3750 - Page 459

2-429
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
police aggregate
Examples This example shows how to define the aggregate policer parameters and to apply the policer to multiple
classes in a policy map:
Switch(config)# mls qos aggregate-policer agg_policer1 10000 1000000 exceed-action drop
Switch(config)# policy-map policy2
Switch(config-pmap)# class class1
Switch(config-pmap-c)# police aggregate agg_policer1
Switch(config-pmap-c)# exit
Switch(config-pmap)# class class2
Switch(config-pmap-c)# set dscp 10
Switch(config-pmap-c)# police aggregate agg_policer1
Switch(config-pmap-c)# exit
Switch(config-pmap)# class class3
Switch(config-pmap-c)# trust dscp
Switch(config-pmap-c)# police aggregate agg_policer2
Switch(config-pmap-c)# exit
You can verify your settings by entering the show mls qos aggregate-policer privileged EXEC
command.
Related Commands Command Description
mls qos aggregate-policer Defines policer parameters, which can be shared by multiple
classes within a policy map.
show mls qos aggregate-policer Displays the quality of service (QoS) aggregate policer
configuration.