2-348
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
macro name
You can modify a macro by creating a new macro with the same name as the existing macro. The newly
created macro overwrites the existing macro but does not affect the configuration of those interfaces on
which the original macro was applied.
Examples This example shows how to create a macro that defines the duplex mode and speed:
Switch(config)# macro name duplex
Enter macro commands one per line. End with the character ‘@’.
duplex full
speed auto
@
This example shows how create a macro with # macro keywords:
Switch(config)# macro name test
switchport access vlan $VLANID
switchport port-security maximum $MAX
#macro keywords $VLANID $MAX
@
This example shows how to display the mandatory keyword values before you apply the macro to an
interface:
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# macro apply test ?
WORD keyword to replace with a value e.g $VLANID,$MAX
<cr>
Switch(config-if)# macro apply test $VLANID ?
WORD Value of first keyword to replace
Switch(config-if)# macro apply test $VLANID 2
WORD keyword to replace with a value e.g $VLANID,$MAX
<cr>
Switch(config-if)# macro apply test $VLANID 2 $MAX ?
WORD Value of second keyword to replace
Related Commands Command Description
macro apply Applies a macro on an interface or applies and traces a macro on an
interface.
macro description Adds a description about the macros that are applied to an interface.
macro global Applies a macro on a switch or applies and traces a macro on a switch
macro global description Adds a description about the macros that are applied to the switch.
show parser macro Displays the macro definition for all macros or for the specified macro.
To Next Page
Loading...
