Cisco Catalyst 3750 User Manual

2-8
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
archive copy-sw
archive copy-sw
Use the archive copy-sw privileged EXEC command on the stack master to copy the running image
from the flash memory on one stack member to the flash memory on one or more other members.
archive copy-sw [/destination-system destination-stack-member-number] [/force-reload]
[leave-old-sw] [/no-set-boot] [/overwrite] [/reload] [/safe] source-stack-member-number
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines The current software image is not overwritten with the copied image.
Both the software image and HTML files are copied.
The new image is copied to the flash: file system.
The BOOT environment variable is changed to point to the new software image on the flash: file system.
Image names are case sensitive; the image file is provided in tar format.
Note To successfully use the archive copy-sw privileged EXEC command, you must have downloaded from
a TFTP server the images for both the member switch being added and the master. You use the archive
download-sw privileged EXEC command to perform the download.
/destination-system
destination-stack-
member-number
(Optional) The number of the member to which to copy the running image.
The range is 1 to 9.
/force-reload (Optional) Unconditionally force a system reload after successfully
downloading the software image.
/leave-old-sw (Optional) Keep the old software version after a successful download.
/no-set-boot (Optional) Do not alter the setting of the BOOT environment variable to
point to the new software image after it is successfully downloaded.
/overwrite (Optional) Overwrite the software image in flash memory with the
downloaded one.
/reload (Optional) Reload the system after downloading the image unless the
configuration has been changed and not been saved.
/safe (Optional) Keep the current software image; do not delete it to make room
for the new software image before the new image is downloaded. The current
image is deleted after the download.
source-stack-member-
number
The number of the member from which to copy the running image. The range
is 1 to 9.
Release Modification
12.1(11)AX This command was introduced.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing