Cisco Catalyst 3750 User Manual

Contents
v
Catalyst 3750 Switch Command Reference
OL-8552-07
clear nmsp statistics 2-85
clear pagp 2-86
clear port-security 2-87
clear spanning-tree counters 2-89
clear spanning-tree detected-protocols 2-90
clear vmps statistics 2-91
clear vtp counters 2-92
cluster commander-address 2-93
cluster discovery hop-count 2-95
cluster enable 2-96
cluster holdtime 2-97
cluster member 2-98
cluster outside-interface 2-100
cluster run 2-101
cluster standby-group 2-102
cluster timer 2-104
define interface-range 2-106
delete 2-108
deny (ARP access-list configuration) 2-110
deny (IPv6 access-list configuration) 2-112
deny (MAC access-list configuration) 2-117
diagnostic monitor 2-120
diagnostic schedule 2-123
diagnostic start 2-125
dot1x 2-127
dot1x auth-fail max-attempts 2-129
dot1x auth-fail vlan 2-131
dot1x control-direction 2-133
dot1x credentials (global configuration) 2-135
dot1x critical (global configuration) 2-136
dot1x critical (interface configuration) 2-138
dot1x default 2-140
dot1x fallback 2-141
dot1x guest-vlan 2-142
dot1x host-mode 2-145

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing