Cisco Catalyst 3750 User Manual

2-498
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show auto qos
service-policy input AutoQoS-Police-CiscoPhone
<output truncated>
This is an example of output from the show auto qos interface interface-id command when the auto
qos voip cisco-phone interface configuration command is entered:
Switch> show auto qos interface fastethernet1/0/2
FastEthernet1/0/2
auto qos voip cisco-softphone
This is an example of output from the show auto qos command when auto-QoS is disabled on the switch:
Switch> show auto qos
AutoQoS not enabled on any interface
This is an example of output from the show auto qos interface interface-id command when auto-QoS
is disabled on an interface:
Switch> show auto qos interface gigabitethernet3/0/1
AutoQoS is disabled
Related Commands Command Description
auto qos voip Automatically configures QoS for VoIP within a QoS domain.
debug auto qos Enables debugging of the auto-QoS feature.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing