Cisco Catalyst 3750 - Page 596

2-566
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show interfaces
Note Though visible in the command-line help strings, the crb, fair-queue, irb, mac-accounting,
precedence, random-detect, rate-limit, and shape keywords are not supported.
Command Modes Privileged EXEC
Command History
Usage Guidelines The show interfaces capabilities command with different keywords has these results:
• Use the show interfaces capabilities module number command to display the capabilities of all
interfaces on that switch in the stack. If there is no switch with that module number in the stack,
there is no output.
• Use the show interfaces interface-id capabilities to display the capabilities of the specified
interface.
• Use the show interfaces capabilities (with no module number or interface ID) to display the
capabilities of all interfaces in the stack.
tengigabitethernet Display the status of a connected ten-gigabit module.
transceiver [detail |
properties]
(Optional) Display the physical properties of a CWDM
1
or DWDM
2
small
form-factor (SFP) module interface. The keywords have these meanings:
• detail—(Optional) Display calibration properties, including high and low
numbers and any alarm information.
• properties—(Optional) Display speed, duplex, and inline power settings on
an interface.
trunk Display interface trunk information. If you do not specify an interface, only
information for active trunking ports appears.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
1. Coarse wavelength-division multiplexer
2. Dense wavelength-division multiplexer
Release Modification
12.1(11)AX This command was introduced.
12.1(14)EA1 Support for the capabilities keyword was added.
12.2(20)SE The private-vlan mapping, backup, transceiver calibration, detail, and
properties, keywords were added.
12.2(25)SEA The calibration keyword was removed.
12.2(25)SEE Added the backup, counters, detail, and trunk keywords.
12.2(44)SE Added the tengigabitethernet interface-id transceiver detail keywords.