EasyManuals Logo

Cisco Catalyst 3750 User Manual

Cisco Catalyst 3750
1154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #636 background imageLoading...
Page #636 background image
2-606
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show ip verify source
On the Gigabit Ethernet 4 interface, IP source guard with source IP and MAC address filtering is
enabled, and static IP source bindings are configured on VLANs 10 and 11. For VLANs 12 to 20,
the default port ACL is applied on the interface for the VLANs on which IP source guard is not
configured.
On the Gigabit Ethernet 5 interface, IP source guard with source IP and MAC address filtering is
enabled and configured with a static IP binding, but port security is disabled. The switch cannot
filter source MAC addresses.
This is an example of output on an interface on which IP source guard is disabled:
Switch> show ip verify source gigabitethernet1/6
IP source guard is not configured on the interface gi1/6.
Related Commands Command Description
ip verify source Enables IP source guard on an interface.

Table of Contents

Other manuals for Cisco Catalyst 3750

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750 and is the answer not in the manual?

Cisco Catalyst 3750 Specifications

General IconGeneral
Device TypeSwitch
Switching Capacity32 Gbps
Forwarding Rate38.7 Mpps
Stacking Bandwidth32 Gbps
RAM128 MB
Jumbo Frame SupportYes
Switch TypeManaged
ModelCatalyst 3750 Series
Uplink InterfacesSFP
Form FactorRack-mountable
MAC Address Table Size12, 000 entries
Routing ProtocolRIP, OSPF, EIGRP
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesLayer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)PoE
Operating Temperature-5 - 45 °C
Operating Humidity10% to 85% non-condensing

Related product manuals