Cisco Catalyst 3750 User Manual

2-612
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show ipv6 access-list
Related Commands
eq An equal operand that compares the source or destination ports of TCP or
UDP packets.
bgp (matches) Border Gateway Protocol. The protocol type that the packet is equal to and
the number of matches.
sequence 10 Sequence in which an incoming packet is compared to lines in an access
list. Access list lines are ordered from first priority (lowest number, for
example, 10) to last priority (highest number, for example, 80).
Table 2-31 show ipv6 access-list Field Descriptions (continued)
Field Description
Command Description
clear ipv6 access-list Resets the IPv6 access list match counters.
ipv6 access-list Defines an IPv6 access list and puts the switch into IPv6 access-list
configuration mode.
sdm prefer Configures an SDM template to optimize system resources based on how the
switch is being used.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing