Cisco Catalyst 3750 - Page 778

2-748
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
snmp-server enable traps
dot1x [auth-fail-vlan |
guest-vlan |
no-auth-fail-vlan |
no-guest-vlan]
(Optional) Enable IEEE 802.1x traps. The keywords have these meanings:
• auth-fail-vlan—(Optional) Generate a trap when the port moves to the
configured restricted VLAN.
• guest-vlan—(Optional) Generate a trap when the port moves to the
configured guest VLAN.
• no-auth-fail-vlan—(Optional) Generate a trap when a port tries to enter
the restricted VLAN, but cannot because the restricted VLAN is not
configured.
• no-guest-vlan—(Optional) Generate a trap when a port tries to enter the
guest VLAN, but cannot because the guest VLAN is not configured.
Note When the snmp-server enable traps dot1x command is entered
(without any other keywords specified), all the IEEE 802.1x traps are
enabled.
entity (Optional) Enable SNMP entity traps.
envmon [fan |
shutdown | status |
supply | temperature]
Optional) Enable SNMP environmental traps. The keywords have these
meanings:
• fan—(Optional) Enable fan traps.
• shutdown—(Optional) Enable environmental monitor shutdown traps.
• status—(Optional) Enable SNMP environmental status-change traps.
• supply—(Optional) Enable environmental monitor power-supply traps.
• temperature—(Optional) Enable environmental monitor temperature
traps.
errdisable
[notification-rate
value]
(Optional) Enable errdisable traps. Use notification-rate keyword to set the
maximum value of errdisable traps sent per minute. The range is 0 to 10000;
the default is 0 (no limit imposed; a trap is sent at every occurrence).
flash [insertion |
removal]
(Optional) Enable SNMP FLASH notifications. The keywords have these
meanings:
insertion—(Optional) Generate a trap when a switch (flash) is inserted into
a stack, either physically or because of a power cycle or reload.
removal—(Optional) Generate a trap when a switch (flash) is removed from
a stack, either physically or because of a power cycle or reload.
fru-ctrl (Optional) Generate entity field-replaceable unit (FRU) control traps. In the
stack, this trap refers to the insertion or removal of a switch in the stack.
hsrp (Optional) Enable Hot Standby Router Protocol (HSRP) traps.
ipmulticast (Optional) Enable IP multicast routing traps.
mac-notification (Optional) Enable MAC address notification traps.
msdp (Optional) Enable Multicast Source Discovery Protocol (MSDP) traps.