Cisco Catalyst 3750 User Manual

2-811
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
srr-queue bandwidth share
srr-queue bandwidth share
Use the srr-queue bandwidth share interface configuration command switch to assign the shared
weights and to enable bandwidth sharing on the four egress queues mapped to a port. The ratio of the
weights is the ratio of frequency in which the shaped round robin (SRR) scheduler dequeues packets
from each queue. Use the no form of this command to return to the default setting.
srr-queue bandwidth share weight1 weight2 weight3 weight4
no srr-queue bandwidth share
Syntax Description
Defaults Weight1, weight2, weight3, and weight4 are 25 (1/4 of the bandwidth is allocated to each queue).
Command Modes Interface configuration
Command History
Usage Guidelines The absolute value of each weight is meaningless, and only the ratio of parameters is used.
In shared mode, the queues share the bandwidth among them according to the configured weights. The
bandwidth is guaranteed at this level but not limited to it. For example, if a queue empties and does not
require a share of the link, the remaining queues can expand into the unused bandwidth and share it
among themselves.
If you configure a shaped queue weight to 0 by using the srr-queue bandwidth shape interface
configuration command, this queue participates in SRR shared mode. The weight specified with the
srr-queue bandwidth shape command is ignored, and the weights specified with the srr-queue
bandwidth share interface configuration command for a queue take effect.
When configuring queues for the same port for both shaping and sharing, make sure that you configure
the lowest numbered queue for shaping.
Note The egress queue default settings are suitable for most situations. You should change them only when
you have a thorough understanding of the egress queues and if these settings do not meet your QoS
solution.
weight1 weight2
weight3 weight4
The ratios of weight1, weight2, weight3, and weight4 specify the ratio of the
frequency in which the SRR scheduler dequeues packets. Separate each value
with a space. The range is 1 to 255.
Release Modification
12.1(11)AX This command was introduced.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing