EasyManuals Logo

Cisco Catalyst 3750 User Manual

Cisco Catalyst 3750
1154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #872 background imageLoading...
Page #872 background image
2-842
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
switchport mode private-vlan
switchport mode private-vlan
Use the switchport mode private-vlan interface configuration command to configure a port as a
promiscuous or host private VLAN port. Use the no form of this command to reset the mode to the
appropriate default for the device.
switchport mode private-vlan {host | promiscuous}
no switchport mode private-vlan
Syntax Description
Defaults The default private-VLAN mode is neither host nor promiscuous.
The default switchport mode is dynamic auto.
Command Modes Interface configuration
Command History
Usage Guidelines A private-VLAN host or promiscuous port cannot be a Switched Port Analyzer (SPAN) destination port.
If you configure a SPAN destination port as a private-VLAN host or promiscuous port, the port becomes
inactive.
Do not configure private VLAN on ports with these other features:
Dynamic-access port VLAN membership
Dynamic Trunking Protocol (DTP)
Port Aggregation Protocol (PAgP)
Link Aggregation Control Protocol (LACP)
Multicast VLAN Registration (MVR)
Voice VLAN
A private-VLAN port cannot be a SPAN destination port.
While a port is part of the private-VLAN configuration, any EtherChannel configuration for it is
inactive.
A private-VLAN port cannot be a secure port and should not be configured as a protected port.
host Configure the interface as a private-VLAN host port. Host ports belong to
private-VLAN secondary VLANs and are either community ports or isolated
ports, depending on the VLAN that they belong to.
promiscuous Configure the interface as a private-VLAN promiscuous port. Promiscuous
ports are members of private-VLAN primary VLANs.
Release Modification
12.2(20)SE This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3750

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750 and is the answer not in the manual?

Cisco Catalyst 3750 Specifications

General IconGeneral
Device TypeSwitch
Switching Capacity32 Gbps
Forwarding Rate38.7 Mpps
Stacking Bandwidth32 Gbps
RAM128 MB
Jumbo Frame SupportYes
Switch TypeManaged
ModelCatalyst 3750 Series
Uplink InterfacesSFP
Form FactorRack-mountable
MAC Address Table Size12, 000 entries
Routing ProtocolRIP, OSPF, EIGRP
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesLayer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)PoE
Operating Temperature-5 - 45 °C
Operating Humidity10% to 85% non-condensing

Related product manuals