Cisco Catalyst 3750 User Manual

2-910
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
vtp (global configuration)
Defaults The default filename is flash:vlan.dat.
The default mode is server mode.
No domain name or password is defined.
No password is configured.
Pruning is disabled.
The default version is Version 1.
Command Modes Global configuration
Command History
Usage Guidelines When you save VTP mode, domain name, and VLAN configurations in the switch startup configuration
file and reboot the switch, the VTP and VLAN configurations are selected by these conditions:
• If both the VLAN database and the configuration file show the VTP mode as transparent and the
VTP domain names match, the VLAN database is ignored. The VTP and VLAN configurations in
the startup configuration file are used. The VLAN database revision number remains unchanged in
the VLAN database.
• If the startup VTP mode is server mode, or the startup VTP mode or domain names do not match the
VLAN database, VTP mode and VLAN configuration for the first 1005 VLANs are selected by
VLAN database information, and VLANs greater than 1005 are configured from the switch
configuration file.
The vtp file filename cannot be used to load a new database; it renames only the file in which the existing
database is stored.
Follow these guidelines when configuring a VTP domain name:
• The switch is in the no-management-domain state until you configure a domain name. While in the
no-management-domain state, the switch does not send any VTP advertisements even if changes
occur to the local VLAN configuration. The switch leaves the no-management-domain state after it
receives the first VTP summary packet on any port that is trunking or after you configure a domain
name by using the vtp domain command. If the switch receives its domain from a summary packet,
it resets its configuration revision number to 0. After the switch leaves the no-management-domain
state, it can no be configured to re-enter it until you clear the NVRAM and reload the software.
• Domain names are case-sensitive.
• After you configure a domain name, it cannot be removed. You can only reassign it to a different
domain.
Release Modification
12.1(11)AX This command was introduced.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing