Cisco Catalyst 3750 User Manual

A-25
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix A Catalyst 3750 Switch Bootloader Commands
unset
The BOOT environment variable can also be reset by using the no boot system global configuration
command.
The ENABLE_BREAK environment variable can also be reset by using the no boot enable-break
global configuration command.
The HELPER environment variable can also be reset by using the no boot helper global configuration
command.
The CONFIG_FILE environment variable can also be reset by using the no boot config-file global
configuration command.
The HELPER_CONFIG_FILE environment variable can also be reset by using the no boot
helper-config-file global configuration command.
The bootloader prompt string (PS1) can be up to 120 printable characters except the equal sign (=).
Examples This example shows how to reset the prompt string to its previous setting:
switch: unset PS1
switch:
Related Commands Command Description
set Sets or displays environment variables.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing