Configure the Ignore IS-IS Overload Bit Setting in MPLS-TE: Example 344
Configure GMPLS: Example 345
Configure Flexible Name-based Tunnel Constraints: Example 347
Configure an Interarea Tunnel: Example 349
Configure Forwarding Adjacency: Example 349
Configure Unequal Load Balancing: Example 350
Configure PCE: Example 351
Configure Policy-based Tunnel Selection: Example 351
Configure Tunnels for Path Protection: Example 352
Configure Tunnels for Explicit Path Protection: Example 352
Configure Tunnels for Co-existence of Path Protection with Fast Reroute: Example 353
Configure Automatic Bandwidth: Example 353
Configure the MPLS-TE Shared Risk Link Groups: Example 353
Configure the MPLS-TE Auto-Tunnel Backup: Example 356
Configure Point-to-Multipoint TE: Examples 362
Configure Point-to-Multipoint for the Source: Example 363
Configure the Point-to-Multipoint Tunnel: Example 363
Disable a Destination: Example 364
Configure the Point-to-Multipoint Solution: Example 364
Configure MPLS TE Path-selection Cost Limit: Example 368
Additional References 368
CHAPTER 7
Implementing GMPLS UNI 371
Prerequisites for Implementing GMPLS UNI 371
Restrictions for Implementing GMPLS UNI 372
Information About Implementing GMPLS UNI 372
GMPLS UNI vs GMPLS NNI 372
GMPLS LSP Signaling 372
Path Message without an ERO 373
XRO Attribute-set 373
Connection Diversity 373
GMPLS RSVP VRF Signaling 373
DWDM Transponder Integration 374
How to Implement GMPLS UNI 374
Configuring TE for GMPLS UNI 374
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
xiv
Contents
To Next Page
Loading...
Need help?
General
