PurposeCommand or Action
Configures LDP session protection for peers specified by peer-acl
with a maximum duration, in seconds.
session protection [ for peer-acl ] [ duration
seconds ]
Example:
RP/0/RP0/CPU0:router(config-ldp)# session
protection for peer_acl_1 duration 60
Step 3
commit—Saves the configuration changes and remains within the
configuration session.
Use the commit or end command.
Step 4
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Related Topics
Session Protection, on page 16
Configuring LDP Session Protection: Example, on page 83
Configuring LDP IGP Synchronization: OSPF
Perform this task to configure LDP IGP Synchronization under OSPF.
By default, there is no synchronization between LDP and IGPs.Note
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
50
Implementing MPLS Label Distribution Protocol
Configuring LDP IGP Synchronization: OSPF
To Next Page
Loading...
