PurposeCommand or Action
Configures the LMP unicast router ID for GMPLS.
router-id ipv4 unicast address
Example:
RP/0/RP0/CPU0:router(config-lmp-gmpls-uni)#
Step 4
router-id ipv4 unicast 10.10.4.4
commit—Saves the configuration changes and remains within
the configuration session.
Use the commit or end command.
Step 5
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Configuring an LMP Neighbor
Perform this task to configure an LMP neighbor for a GMPLS UNI tunnel.
SUMMARY STEPS
1.
configure
2.
lmp
3.
gmpls optical-uni
4.
neighbor name
5.
ipcc routed
6.
router-id ipv4 unicast address
7.
Use the commit or end command.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
385
Implementing GMPLS UNI
Configuring LMP for GMPLS UNI
To Next Page
Loading...
