Cisco CRS Configuration Guide

PurposeCommand or Action
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Related Topics
RSVP Authentication Design, on page 118
RSVP Authentication by Using All the Modes: Example, on page 152
Configuring the Window Size for an Interface for RSVP Authentication
Perform this task to configure the window size for an interface for RSVP authentication to check the validity
of the sequence number received.
SUMMARY STEPS
1.
configure
2.
rsvp interface type interface-path-d
3.
authentication
4.
window-size N
5.
Use the commit or end command.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Enters RSVP interface configuration mode.
rsvp interface type interface-path-d
Example:
RP/0/RP0/CPU0:router(config)# rsvp
Step 2
interface POS 0/2/1/0
RP/0/RP0/CPU0:router(config-rsvp-if)#
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
140
Implementing RSVP for MPLS-TE and MPLS O-UNI
Configuring an Interface for RSVP Authentication

Cisco CRS Specifications

General

Brand	Cisco
Model	CRS
Category	Network Router
Language	English