Cisco CRS Configuration Guide

PurposeCommand or Action
Enters GMPLS UNI configuration submode.gmpls optical-uni
Example:
RP/0/RP0/CPU0:router(config-mpls-te)# gmpls
optical-uni
Step 3
Enters GMPLS UNI controller submode.
controller dwdm interface
Example:
RP/0/RP0/CPU0:router(config-te-gmpls)#
controller dwdm 0/1/0/1
Step 4
Enters the submode to configure tunnel-specific information
for a GMPLS UNI controller.
tunnel-properties
Example:
RP/0/RP0/CPU0:router(config-te-gmpls-cntl)#
tunnel-properties
Step 5
Specifies the path-option for a headend router of a GMPLS
tunnel.
path-option 10 no-ero [xro-attribute-set name ]
lockdown
Example:
RP/0/RP0/CPU0:router(config-te-gmpls-tun)#
Step 6
path-option 10 no-ero xro-attribute-set A01
lockdown
commit—Saves the configuration changes and remains within
the configuration session.
Use the commit or end command.
Step 7
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Configuring Connection Diversity
Perform this task to specify exclusions for an attribute set for LSP diversity, under MPLS-TE attribute-set
configuration mode.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
382
Implementing GMPLS UNI
Configuring TE for GMPLS UNI

Cisco CRS Specifications

General

Brand	Cisco
Model	CRS
Category	Network Router
Language	English