Cisco CRS

Configuring MPLS-TE Forwarding Adjacency
Perform this task to configure forwarding adjacency on a specific tunnel-te interface.
SUMMARY STEPS
1.
configure
2.
interface tunnel-te tunnel-id
3.
forwarding-adjacency holdtime value
4.
Use the commit or end command.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Enters MPLS-TE interface configuration mode.
interface tunnel-te tunnel-id
Example:
RP/0/RP0/CPU0:router(config)# interface
Step 2
tunnel-te 1
Configures forwarding adjacency using an optional specific holdtime
value. By default, this value is 0 (milliseconds).
forwarding-adjacency holdtime value
Example:
RP/0/RP0/CPU0:router(config-if)#
Step 3
forwarding-adjacency holdtime 60
commit—Saves the configuration changes, and remains within the
configuration session.
Use the commit or end command.
Step 4
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
277
Implementing MPLS Traffic Engineering
Configuring MPLS-TE Forwarding Adjacency