Cisco CRS

PurposeCommand or Action
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Related Topics
Key-source Key-chain, on page 121
Security Association, on page 120
RSVP Neighbor Authentication: Example, on page 151
Configuring a Lifetime for RSVP Neighbor Authentication
Perform this task to configure a lifetime for security association for RSVP neighbor authentication mode.
SUMMARY STEPS
1.
configure
2.
rsvp neighbor IP-address authentication
3.
life-time seconds
4.
Use the commit or end command.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Enters RSVP neighbor authentication configuration mode. Use the
rsvp neighbor command to specify a neighbor under RSVP.
rsvp neighbor IP-address authentication
Example:
RP/0/RP0/CPU0:router(config)# rsvp neighbor
Step 2
IP address
IP address of the neighbor. A single IP address for a specific
neighbor; usually one of the neighbor's physical or logical
(loopback) interfaces.
1.1.1.1 authentication
RP/0/RP0/CPU0:router(config-rsvp-nbor-auth)#
authentication
Configures the RSVP authentication parameters.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
143
Implementing RSVP for MPLS-TE and MPLS O-UNI
Configuring RSVP Neighbor Authentication