Cisco CRS Configuration Guide

PurposeCommand or Action
traps rsvp all
commit—Saves the configuration changes and remains within
the configuration session.
Use the commit or end command.
Step 5
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Related Topics
RSVP MIB, on page 117
Enable RSVP Traps: Example, on page 150
How to Implement RSVP Authentication
There are three types of RSVP authentication modes—global, interface, and neighbor. These topics describe
how to implement RSVP authentication for each mode:
Configuring Global Configuration Mode RSVP Authentication
These tasks describe how to configure RSVP authentication in global configuration mode:
Enabling RSVP Authentication Using the Keychain in Global Configuration Mode
Perform this task to enable RSVP authentication for cryptographic authentication by specifying the keychain
in global configuration mode.
You must configure a keychain before completing this task (see Cisco IOS XR System Security
Configuration Guide for the Cisco CRS Router).
Note
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
133
Implementing RSVP for MPLS-TE and MPLS O-UNI
How to Implement RSVP Authentication

Cisco CRS Specifications

General

Operating System	Cisco IOS XR
Product Type	Core Router
Form Factor	Modular Chassis
Dimensions	Varies by chassis type
Weight	Varies by chassis type
Architecture	Distributed
Switch Fabric	Multi-stage
Interface Support	Ethernet, SONET/SDH, OTN
Interfaces/Ports	Varies by line card
Port Density	Varies by line card
Routing Protocol	BGP, IS-IS, OSPF, MPLS
Management	CLI, SNMP
Power Supply	Redundant, hot-swappable
Cooling	Redundant, Hot-swappable Fan Trays
Supported Protocols	IPv4, IPv6, MPLS
Management Interfaces	Ethernet, console
Security Features	ACLs