from 3.3.3.3:0 for pfx_acl3
!
!
!
!
interface GigabitEthernet0/0/0/0
igp sync delay on-session-up disable
discovery quick-start disable
discovery hello holdtime 30
discovery hello interval 10
address-family ipv4
igp auto-config disable
discovery transport-address interface
mldp disable
!
!
interface GigabitEthernet0/0/0/1
igp sync delay on-session-up 10
address-family ipv4
discovery transport-address 1.1.1.1
!
!
interface GigabitEthernet0/0/0/2
!
!
Additional References
For additional information related to Implementing MPLS Label Distribution Protocol, refer to the following
references:
Related Documents
Document TitleRelated Topic
MPLS Label Distribution Protocol Commands module
in Cisco IOS XR MPLS Command Reference for the
Cisco CRS Router.
LDP Commands
Standards
TitleStandards
—
No new or modified standards are supported by this
feature, and support for existing standards has not
been modified by this feature.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
99
Implementing MPLS Label Distribution Protocol
Additional References
To Next Page
Loading...
Need help?
General
