Configure MPLS TE Path-selection Cost Limit: Example
This example shows how to set the path-selection cost limit for MPLS TE tunnels at global, TE tunnel interface,
and path-option attribute-set levels. By default, the cost-limit set at path-option attribute set takes the priority,
if all options are configured and per tunnel interface level takes priority over global cost-limit. At per tunnel
interface level, the global cost-limit takes the priority.
interface tunnel-te1
path-selection cost-limit 2
!
mpls traffic-eng
attribute-set path-option PO3AttrSet
path-selection cost-limit 3
!
path-selection cost-limit 1
!
!
Additional References
For additional information related to implementing MPLS-TE, refer to the following references:
Related Documents
Document TitleRelated Topic
MPLS Traffic Engineering Commands module in
Cisco IOS XR MPLS Command Reference for the
Cisco CRS Router.
MPLS-TE commands
Standards
TitleStandards
—
No new or modified standards are supported by this
feature, and support for existing standards has not
been modified by this feature.
MIBs
MIBs LinkMIBs
To locate and download MIBs using Cisco IOS XR
software, use the Cisco MIB Locator found at the
following URL and choose a platform under the Cisco
Access Products menu: http://cisco.com/public/
sw-center/netmgmt/cmtk/mibs.shtml
—
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
368
Implementing MPLS Traffic Engineering
Configure MPLS TE Path-selection Cost Limit: Example
To Next Page
Loading...
Need help?
General
