Cisco CRS

PurposeCommand or Action
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Configuring Other Tunnel Properties for a GMPLS UNI Tunnel
Perform this task to configure the optional tunnel properties for a GMPLS UNI tunnel. This configuration is
optional, and if omitted, the GMPLS tunnel is established with the default property values.
SUMMARY STEPS
1.
configure
2.
mpls traffic-eng
3.
gmpls optical-uni
4.
controller dwdm interface
5.
tunnel-properties
6.
priority setup-priority hold-priority
7.
record-route
8.
signalled-name name
9.
logging events lsp-status state
10.
Use the commit or end command.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Enters MPLS-TE configuration mode.mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls
Step 2
traffic-eng
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
379
Implementing GMPLS UNI
Configuring TE for GMPLS UNI