Cisco CRS

Configuring an LMP Controller
Perform this task to configure an LMP link for a GMPLS UNI controller.
SUMMARY STEPS
1.
configure
2.
lmp
3.
gmpls optical-uni
4.
controller dwdm controller
5.
neighbor name
6.
link-id ipv4 unicast address
7.
neighbor link-id ipv4 unicast address
8.
neighbor interface-id unnumbered interface-id
9.
Use the commit or end command.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Enters LMP configuration mode.lmp
Example:
RP/0/RP0/CPU0:router(config)# lmp
Step 2
Enters GMPLS UNI configuration submode.gmpls optical-uni
Example:
RP/0/RP0/CPU0:router(config-lmp)# gmpls
Step 3
optical-uni
Specifies a controller for GMPLS UNI.
controller dwdm controller
Example:
RP/0/RP0/CPU0:router(config-lmp-gmpls-uni)#
Step 4
controller dwdm 0/4/0/0
Specifies an LMP neighbor for GMPLS and enters LMP
GMPLS UNI neighbor configuration submode.
neighbor name
Example:
RP/0/RP0/CPU0:router(config-lmp-gmpls-uni-cntl)#
Step 5
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
387
Implementing GMPLS UNI
Configuring LMP for GMPLS UNI