Cisco CRS

PurposeCommand or Action
Displays the information for all P2MP tunnels.show mpls traffic-eng tunnels [p2mp]
Example:
RP/0/RP0/CPU0:router# show mpls traffic-eng
Step 11
tunnels p2mp
Related Topics
Point-to-Multipoint Traffic-Engineering Overview, on page 193
Configure the Point-to-Multipoint Tunnel: Example, on page 363
Configure the Point-to-Multipoint Solution: Example, on page 364
Enabling Soft-Preemption on a Node
Perform this task to enable the soft-preemption feature in the MPLS TE configuration mode. By default, this
feature is disabled. You can configure the soft-preemption feature for each node. It has to be explicitly enabled
for each node.
SUMMARY STEPS
1.
configure
2.
mpls traffic-eng
3.
soft-preemption
4.
timeout seconds
5.
Use the commit or end command.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Enters MPLS-TE configuration mode.mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls traffic-eng
Step 2
Enables soft-preemption on a node.soft-preemption
Step 3
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
319
Implementing MPLS Traffic Engineering
Enabling Soft-Preemption on a Node