Cisco CRS Configuration Guide

DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Configures an MPLS-TE tunnel interface.
interface tunnel-te tunnel-id
Example:
RP/0/RP0/CPU0:router(config)#interface
tunnel-te 1
Step 2
Sets the upper limit on the path aggregate admin-weight when
computing paths for MPLS TE LSPs for the specified MPLS TE tunnel.
path-selection cost-limit cost-limit
Example:
RP/0/RP0/CPU0:router(config-if)#
path-selection cost-limit 2
Step 3
commit—Saves the configuration changes and remains within the
configuration session.
Use the commit or end command.
Step 4
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Configuring Path-selection Cost Limit per Path-option Attribute-set
Perform these steps to configure path-selection cost limit per path-option attribute-set:
SUMMARY STEPS
1.
configure
2.
mpls traffic-eng
3.
attribute-set path-option attribute-set-name
4.
path-selection cost-limit 3
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
338
Implementing MPLS Traffic Engineering
Configuring Path-selection Cost Limit

Cisco CRS Specifications

General

Brand	Cisco
Model	CRS
Category	Network Router
Language	English