ModificationRelease
No modification.Release 3.8.0
The RSVP MIB feature was added.Release 3.9.0
•
Prerequisites for Implementing RSVP for MPLS-TE and MPLS O-UNI , page 112
•
Information About Implementing RSVP for MPLS-TE and MPLS O-UNI , page 112
•
Information About Implementing RSVP Authentication, page 118
•
How to Implement RSVP, page 122
•
How to Implement RSVP Authentication, page 133
•
Configuration Examples for RSVP, page 146
•
Configuration Examples for RSVP Authentication, page 150
•
Additional References, page 152
Prerequisites for Implementing RSVP for MPLS-TE and MPLS
O-UNI
These prerequisites are required to implement RSVP for MPLS-TE and MPLS O-UNI:
•
You must be in a user group associated with a task group that includes the proper task IDs. The command
reference guides include the task IDs required for each command. If you suspect user group assignment
is preventing you from using a command, contact your AAA administrator for assistance.
•
Either a composite mini-image plus an MPLS package, or a full image, must be installed.
Information About Implementing RSVP for MPLS-TE and MPLS
O-UNI
To implement MPLS RSVP, you must understand the these concepts:
Related Topics
How to Implement RSVP Authentication, on page 133
Overview of RSVP for MPLS-TE and MPLS O-UNI
RSVP is a network control protocol that enables Internet applications to signal LSPs for MPLS-TE, and LSPs
for O-UNI. The RSVP implementation is compliant with the IETF RFC 2205, RFC 3209, and OIF2000.125.7.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
112
Implementing RSVP for MPLS-TE and MPLS O-UNI
Prerequisites for Implementing RSVP for MPLS-TE and MPLS O-UNI
To Next Page
Loading...
Need help?
General
