Cisco CRS

PurposeCommand or Action
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Configuring LSP Diversity
To configure an XRO attribute-set as part of the path-option for MPLS-TE, and to specify exclusions for an
attribute set for LSP diversity, follow these procedures:
Configuring XRO Attribute-set
Perform this task to configure XRO attribute set in the GMPLS UNI tunnel path-option, under MPLS-TE
submode.
SUMMARY STEPS
1.
configure
2.
mpls traffic-eng
3.
gmpls optical-uni
4.
controller dwdm interface
5.
tunnel-properties
6.
path-option 10 no-ero [xro-attribute-set name ] lockdown
7.
Use the commit or end command.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Enters MPLS-TE configuration mode.mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls traffic-eng
Step 2
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
381
Implementing GMPLS UNI
Configuring TE for GMPLS UNI