PurposeCommand or Action
(Optional)
Displays the status of the LDP graceful restart feature. The output
of this command not only shows states of different graceful restart
show mpls ldp graceful-restart
Example:
RP/0/RP0/CPU0:router# show mpls ldp
graceful-restart
Step 11
timers, but also a list of graceful restart neighbors, their state, and
reconnect count.
(Optional)
Displays the status of the LDP graceful restart for all VRFs.
show mpls ldp vrf all graceful-restart
Example:
RP/0/RP0/CPU0:router# show mpls ldp vrf all
graceful-restart
Step 12
(Optional)
Displays the status of the LDP graceful restart for the specified
VRF.
show mpls ldp vrf vrf-name graceful-restart
Example:
RP/0/RP0/CPU0:router# show mpls ldp vrf red
graceful-restart
Step 13
Related Topics
LDP Graceful Restart, on page 11
Phases in Graceful Restart, on page 12
Recovery with Graceful-Restart, on page 14
Configuring LDP Nonstop Forwarding with Graceful Restart: Example, on page 82
Configuring Label Acceptance Control (Inbound Filtering)
Perform this task to configure LDP inbound label filtering.
By default, there is no inbound label filtering performed by LDP and thus an LSR accepts (and retains)
all remote label bindings from all peers.
Note
SUMMARY STEPS
1.
configure
2.
mpls ldp
3.
[vrf vrf-name] address-family { ipv4}
4.
label remote accept from ldp-id for prefix-acl
5.
Use the commit or end command.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
46
Implementing MPLS Label Distribution Protocol
Configuring Label Acceptance Control (Inbound Filtering)
To Next Page
Loading...
Need help?
General
