Cisco CRS

signalled-bandwidth 50000
autoroute announce
destination 1.5.177.2
policy-class 2
path-option 1 dynamic
Related Topics
Configuring Policy-based Tunnel Selection, on page 286
Policy-Based Tunnel Selection Functions, on page 187
Policy-Based Tunnel Selection, on page 186
Configure Tunnels for Path Protection: Example
The path protection feature is configured on only the source router. The dynamic path option is a prerequisite
to configure a path protection.
interface tunnel-te150
ipv4 unnumbered Loopback150
autoroute announce
destination 151.151.151.151
affinity 11 mask 11
path-protection
path-option 2 explicit name p2mp3-p2mp4-p2mp5_1
path-option 10 dynamic
Related Topics
Path Protection, on page 188
Pre-requisites for Path Protection, on page 188
Restrictions for Path Protection, on page 189
Restrictions for Explicit Path Protection, on page 189
Configure Tunnels for Explicit Path Protection: Example
The path protection feature is configured on only the source router. The protected-by keyword configures
path protection for an explicit path that is protected by another explicit path.
interface tunnel-te150
ipv4 unnumbered Loopback150
autoroute announce
destination 151.151.151.151
affinity 11 mask 11
path-protection
path-option 2 explicit name p2mp3-p2mp4-p2mp5_1 protected-by 10
path-option 10 explicit
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
352
Implementing MPLS Traffic Engineering
Configure Tunnels for Path Protection: Example