PurposeCommand or Action
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without committing
the configuration changes.
Related Topics
GMPLS Support , on page 178
Configuring OSPF over IPCC
Perform this task to configure OSPF over IPCC on both the headend and tailend routers. The IGP interface
ID is configured for control network, specifically for the signaling plane in the optical domain.
IPCC support is restricted to routed, out-of-fiber, and out-of-band.Note
SUMMARY STEPS
1.
configure
2.
router ospf process-name
3.
area area-id
4.
interface type interface-path-id
5.
exit
6.
exit
7.
mpls traffic-eng router-id {type interface-path-id | ip-address }
8.
area area-id
9.
Use the commit or end command.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
244
Implementing MPLS Traffic Engineering
Configuring GMPLS
To Next Page
Loading...
Need help?
General
