Cisco CRS Configuration Guide

PurposeCommand or Action
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration session,
without committing the configuration changes.
Displays the output for the P2MP-TE tunnel interface
that has IPv6 multicast enabled.
show pim ipv6 interface type interface-path-id
Example:
RP/0/RP0/CPU0:router# show pim ipv6 interface
Step 10
tunnel-mte 1
Related Topics
Point-to-Multipoint Traffic-Engineering Overview, on page 193
Configure Point-to-Multipoint for the Source: Example, on page 363
Configure the Point-to-Multipoint Solution: Example, on page 364
Configuring the Static Group for the Point-to-Multipoint Interface, on page 309
Configuring the Static Group for the Point-to-Multipoint Interface
Perform this task to configure the static group on the Point-to-Multipoint (P2MP) interface to forward specified
multicast traffic over P2MP LSP.
SUMMARY STEPS
1.
configure
2.
router mld
3.
vrf vrf-name
4.
interface tunnel-mte tunnel-id
5.
static-group group-address
6.
Use the commit or end command.
7.
show mrib ipv6 route source-address
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
309
Implementing MPLS Traffic Engineering
Configuring Point-to-Multipoint TE

Cisco CRS Specifications

General

Operating System	Cisco IOS XR
Product Type	Core Router
Form Factor	Modular Chassis
Dimensions	Varies by chassis type
Weight	Varies by chassis type
Architecture	Distributed
Switch Fabric	Multi-stage
Interface Support	Ethernet, SONET/SDH, OTN
Interfaces/Ports	Varies by line card
Port Density	Varies by line card
Routing Protocol	BGP, IS-IS, OSPF, MPLS
Management	CLI, SNMP
Power Supply	Redundant, hot-swappable
Cooling	Redundant, Hot-swappable Fan Trays
Supported Protocols	IPv4, IPv6, MPLS
Management Interfaces	Ethernet, console
Security Features	ACLs