PurposeCommand or Action
commit—Saves the configuration changes and remains within
the configuration session.
Use the commit or end command.
Step 5
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Configuring GMPLS UNI Controller as a Tunnel Head
Perform this task to configure the tunnel properties for a GMPLS UNI controller.
This configuration designates the controller as a tunnel-head, rather than a tunnel tail. After the tunnel properties
are configured, the incoming path messages are rejected and any existing tail-end tunnel is torn down.
SUMMARY STEPS
1.
configure
2.
mpls traffic-eng
3.
gmpls optical-uni
4.
controller dwdm interface
5.
tunnel-properties
6.
tunnel-id number
7.
destination ipv4 unicast address
8.
path-option 10 no-ero lockdown
9.
Use the commit or end command.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
377
Implementing GMPLS UNI
Configuring TE for GMPLS UNI
To Next Page
Loading...
Need help?
General
