Cisco CRS Configuration Guide

PurposeCommand or Action
Example:
RP/0/RP/0/RP0/CPU0:router
(config-ldp-mldp-af)# end
exiting(yes/no/cancel)?
[cancel]:
•
Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and returns
the router to EXEC mode.
or
RP/0/RP/0/RP0/CPU0:router
(config-ldp-mldp-af)# commit
•
Entering no exits the configuration session and returns the router
to EXEC mode without committing the configuration changes.
•
Entering cancel leaves the router in the current configuration
session without exiting or committing the configuration changes.
•
Use the commit command to save the configuration changes
to the running configuration file and remain within the
configuration session.
Enabling MLDP Static Point to Multipoint LSP
Perform this task to enable static point to multipoint (P2MP) LSP support in MPLS MLDP.
SUMMARY STEPS
1.
configure
2.
mpls ldp
3.
mldp
4.
address-family ipv4
5.
static p2mp ip-address
6.
end or commit
DETAILED STEPS
PurposeCommand or Action
Enters Global Configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
76
Implementing MPLS Label Distribution Protocol
Enabling MLDP

Cisco CRS Specifications

General

Brand	Cisco
Model	CRS
Category	Network Router
Language	English