Cisco CRS Configuration Guide

PurposeCommand or Action
Enters a name that uniquely identifies an OSPF routing process.
router ospf process-name
Example:
RP/0/RP0/CPU0:router(config)# router ospf
Step 2
process-name
Any alphanumeric string no longer than 40 characters without
spaces.
100
Enters the MPLS interface type. For more information, use the
question mark (?) online help function.
mpls traffic-eng router-id ip-address
Example:
RP/0/RP0/CPU0:router(config-ospf)# mpls
Step 3
traffic-eng router-id 192.168.70.1
Enters an OSPF area identifier.
area area-id
Example:
RP/0/RP0/CPU0:router(config-ospf)# area
Step 4
area-id
Either a decimal value or an IP address.
0
Identifies an interface ID. For more information, use the question
mark (?) online help function.
interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config-ospf-ar)#
Step 5
interface POS 0/2/0/0
commit—Saves the configuration changes and remains within the
configuration session.
Use the commit or end command.
Step 6
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Configuring Explicit Paths with ABRs Configured as Loose Addresses
Perform this task to specify an IPv4 explicit path with ABRs configured as loose addresses.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
275
Implementing MPLS Traffic Engineering
Configuring Explicit Paths with ABRs Configured as Loose Addresses

Cisco CRS Specifications

General

Brand	Cisco
Model	CRS
Category	Network Router
Language	English